BSI Un-Cure Super Glue CA Debonder 28 g (1 oz)

Un-Cure debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of Un-Cure will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.

USES

Works Best On:

• All Cyanoacrylates
  

DIRECTIONS

Un-Cure is designed to gently soften cured super glue, also known as cyanoacrylate (CA). When releasing bonded skin (excluding the eye area), simply apply Un-Cure and use a small, rounded object such as a paperclip to separate the skin with a peeling motion. Apply additional Un-Cure as needed until the bonded skin areas are successfully debonded. Afterwards, wash the treated area with soap and water. Any remaining CA will naturally shed within 12 hours as the outer layer of the skin naturally exfoliates. For hard surfaces, effectively remove CA by soaking a cloth or paper towel in Un-Cure and vigorously rubbing the affected areas. It’s important to note that while Un-Cure is effective, it may leave marks on most plastics.